Whirlpool Siamo spiacenti, questa pagina al momento è disponibile solo in lingua inglese.
La versione italiana sarà presto disponibile.
Se desiderate ottenere la licenza per la traduzione per favore scriveteci.
Whirlpool modifier allows to twist an element into a whirlpool around the center of a light effect (take note, it is the light effect center, not the one of the element). You can set the twist angle and the whirlpool direction (right or left).
Twisting Angle is set in degrees from 0 to 1440.
|
|
|
| Angle = 90 |
Angle = 500, element center
coincides with
the light effect center |
Angle = 500, element center
does not coincide with
the light effect center |
Direction of whirlpool twist is set by a drop down menu with two entries Left and Right.
|
|
| Left |
Right |
When Density checkbox is enabled, interval between the whirling lines is increasing gradually (the further from the whirlpool center, the larger is the interval). When the Density checkbox is disabled, the interval is always the same.
|
|
| Density disabled |
Density enabled |
Note! Whirlpool modifier will not give any result being applied to Blob and Ring elements in their initial form. But after even a very slight modification of a blob or a ring with any of modifiers (squeeze it vertically or horizontally, transform into a flower or a star, add a fractal) and you will be able to see the Whirlpool modifier effect.
|
|
|
| Blob element |
Blob
Star modifier applied |
Blob element
with Star and Whirlpool
modifiers applied |
| 
— Spirale