MaskSector Siamo spiacenti, questa pagina al momento è disponibile solo in lingua inglese.
La versione italiana sarà presto disponibile.
Se desiderate ottenere la licenza per la traduzione per favore scriveteci.
MaskSector modifier allows cutting a sector and/or a hole in an element.
The Sector Size parameter sets the part of the element (in degrees) to be drawn: the whole element is 360 degrees, 3/4 of an element – 270 degrees, half of an element - 180 degrees.
|
|
|
| Sector Size = 360 |
Sector Size = 270 |
Sector Size = 180 |
The Angle parameter allows turning a part of an element in any direction. Angle is set in degrees from 0 to 360. The element is turned anticlockwise.
|
|
|
| Angle = 0 |
Angle = 120 |
Angle = 200 |
The Hole Radius parameter sets the radius for a hole cut inside an element. The center of a hole will coincide with the center of a light effect, and not that of an element. If the element's center coincides with the light effect center, the hole will be cut off the center of the element.
|
|
|
| Hole Radius = 20% |
Hole Radius = 60%,
element center
coincides with
light effect center |
Hole Radius = 60%,
element center
does not coincide with
light effect center |
The Softness parameter sets the softness of the cut edges: the higher is the value, the softer are the edges, with the Softness=0 the edges are hard.
|
|
|
| Softness = 0% |
Softness = 10% |
Softness = 50% |
| 
— Settore